Table of Contents
Advertisement
in-ground loops
Install in-ground loops to help protect vehicles from a moving gate. See pages 25 & 29 for wiring instructions.
Refer to loop maunufacturer's
instructions to determine
specific loop dimensions.
It is recommended that a
licenced installer perform
this work.
Outside Property
Illustration not to scale
Inside Property
Side View of
Saw Cut
Sealant
1 1/2"
Backer Rod
Typical
Loop Wire
1/4" Saw Cut
Pavement
Safety Loops
Are placed on each side of the gate to
prevent the gate from closing on a
vehicle in it's path. They will stop or
reverse the cycling of the gate while a
vehicle is in or near the gate's pathway.
Center Loop
Will ONLY HOLD the gate in the Full
Open Position when a vehicle is on the
center loop. However, it WILL NOT stop
or reverse the gate once it starts to
close.
Exit Loop
Automatically opens the gate for exiting
vehicles without having to use a radio
transmitter (remote control). The exit
loop can be placed a minimum of 4 feet
away from the safety loop or far enough
away from the gate so it has opened by
the time the vehicle approaches it.
installation
Safety
4 ft
Loop
4 ft
4 ft
Center
Loop
Saw Cut
4 ft
Safety
Loop
4 ft min.
Exit
4 ft
Loop
4 ft
Loop lead wires are
twisted 6 twists per
foot minimum inside
Run in-ground
loops conduit to
CONTROL BOX.
4 ft
conduit.
Control Box
15
Advertisement
Table of Contents
