Replacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the
The projector will detect the lamp life itself. It will show you a warning message
"Lamp is approaching the end of its useful life in full power operation.
Replacement Suggested!" When you see this message, change the lamp as soon
as possible. Make sure the projector has been cooled down for at least 45
minutes before changing the lamp.
Warning: Lamp compartment is hot! Allow it to cool down before
To remove the lamp:
Turn the projector off by pressing
minutes to cool down. Disconnect the power cord.
Use a screwdriver to remove the screw from the cover. (Illustration #1)
Push up and remove the cover.
Remove the lamp protection film (Illustration #2).
Remove the screw that secures the lamp module (Illustration #3).
Disconnect the lamp connector from the projector. Lift the handle so that
it stands up. Pull out the lamp module by force (Illustration #4).
To replace the lamp module, use a new lamp and reverse the above steps
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.
(POWER). Allow the projector at least 45