Acer U5200 Quick Start Manual

A. Hardware connection:
1. Guide to components
1 2
1 Mini USB
2 LAN port
3 USB Type A
2. Turn on the projector
3. Check the information on the splash
screen
Projector Name (SSID) : AcerProjector 001
Server IP
WEP Key
Check Projector ID, Projector Name (SSID),
Server IP and WEP on the splash screen. The
Server IP will be assigned by the network
with DHCP enabled. Ask your supervisor for
the wireless connection WEP key when WEP is
enabled.

4. Connect to network

a Switch on your system, and activate your
wireless LAN.
3
Projector ID: 7362
: 192.168.100.10
: None
b Scan for avaliable WLAN APs using your
preferred WLAN manager.
c Select and connect to the access point labeled
AcerProjector, or AcerProjectorXXXX.
d Connect the projector to your LAN for a wired
connection.
B. Software installation:
1. The software is stored on the Acer
Projector Gateway.
Please follow the steps below to

download and install:

a Open the internet browser.
b You will automatically be taken to the
welcome page.
c Enter the Server IP address into your browser's
address bar if you do not see the welcome
page.