Direct Color Systems Direct Jet 1024UVHS Maintenance And Troubleshooting Manual page 31

Symptoms
Pressing Control Panel
buttons: Left Arrow, Right
Arrow, or Print Home
doesn't move the media
table.
Pressing Control Panel
buttons: Up Arrow and
Down Arrow, doesn't move
the print engine elevator
up or down.
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx
Check
Check and verify print home (table control lock)
has not been pressed (See Print Home
Description). Press
Check and reseat cable connected to CN3 on the
YACB board.
Check and reseat cable connected to CN11 on
the YACB board.
Check F1, 42 VDC fuse on the YACB board.
Check F2, 5 VDC fuse on the YACB board.
Check the Y-axis motor and gear train.
Check and reseat cable connected to CN1 on the
EIB board and the Z-axis motor.
Check 24VDC fuse on the EIB board.
Check Z-axis Limit sensors, motor and gear train.
.
Go to table of contents
Replace
Replace 42 VDC 2 Amp
Fuse.
Replace 5 VDC 1 Amp.
Fuse.
Replace YACB Board.
Replace Y-axis motor.
Replace Printer Power
Supply
Replace 24 VDC 2 Amp.
Fuse.
Replace EIB board.
Replace Z-axis motor.
Replace Z-axis Limit
sensor.
Replace Printer Power
Supply
31 | P a g e