Direct Color Systems Direct Jet 1024UVHS Maintenance And Troubleshooting Manual page 18

4. Remove the locking bracket holding the unit
to the side plate. Use pliers to remove the
bracket from the side of the print engine.
5. Disconnect the electrical cable that goes to the motor. Do
not leave the gender changer connected to the capping
station. Leave it connected to the wire that is attached
to the printer.
6. Carefully remove the unit.
7. Reverse procedure to install the replacement unit.
8. Select an Initial Charge from the Device Properties screen to get the ink flowing through the
new Capping Station.
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx
Disconnect orange ground wire.
Go to table of contents
18 | P a g e