Replace The Capping Station; Tools Required; Time Required - Direct Color Systems Direct Jet 1024UVHS Maintenance And Troubleshooting Manual

Replace the Capping Station

Replace a Capping Station if:
a. The gaskets no longer form a tight seal around the print heads, and the cleaning cycle does
not perform properly.
b. Some type of physical damage has occurred to the unit.
c. There is an electrical failure of the pump motor.
d. It is more than 90 days old.

Tools Required

Long magnetized Philips head screwdriver
Needle-nose pliers
1. Press the up arrow button until the print engine is at its maximum height. Press
off main power. DO NOT PRESS
2. The Capping Station is mounted to the
printer with 5 Philips head screws (4 hold it
in place + 1 for the orange ground wire).
There is also 1 small electrical connector that
needs to be disconnected.
3. Remove the 4 Philips head screws.
DCS_Direct_Jet_1024UVHS_Maintenance_Troubleshooting_Guide_1.2.docx

Time Required

Approximately 20 minutes
.
Go to table of contents
. Turn
The capping station
17 | P a g e