Checking/Adjusting Headlight Aim; Fuses - Arctic Cat 2013 400 TRV Operator's Manual

2. Push the bulb in and turn it counter-
clockwise.
3. Install the new bulb by turning it
clockwise while pushing in.
4. Install the lens cover.
CAUTION
Tighten the lens cover screws only
until they are snug.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically
and horizontally. The geometric center of
the HIGH beam light zone is to be used
for vertical and horizontal aiming.
1. Position the ATV on a level floor so
the headlights are approximately 6.1
m (20 ft) from an aiming surface
(wall or similar aiming surface).
 NOTE: There should be an aver-
age operating load on the ATV
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. Adjust each headlight by turning the
adjustment knob clockwise to raise
the beam or counterclockwise to
lower the beam until correct aim is
obtained.

Fuses

The fuses are located in a fuse block
under the seat. If there is any type of
electrical system failure, always check
the fuses first.
 NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse case and lift out.
ATV-0070C
CD714A
400
2411-078
550
2411-080
81