Checking/Adjusting Headlight Aim; Fuses; Electrical Output Terminals - Arctic Cat 366 2010 Operator's Manual

CHECKING/
ADJUSTING
HEADLIGHT AIM
The headlights can be adjusted verti-
cally and horizontally. The geometric
center of the HIGH beam light zone is
to be used for vertical and horizontal
aiming.
1. Position the ATV on a level floor
so the headlights are approxi-
mately 6.1 m (20 ft) from an aim-
ing surface (wall or similar aiming
surface).
 NOTE: There should be an aver-
age operating load on the ATV
when adjusting the headlight aim.
2. Measure the distance from the
floor to the mid-point of each
headlight.
3. Using the measurements obtained
in step 2, make horizontal marks
on the aiming surface.
4. Make vertical marks which inter-
sect the horizontal marks on the
aiming surface directly in front of
the headlights.
5. Switch on the lights. Make sure
the HIGH beam is on. DO NOT
USE LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most
intense beam is centered on the
vertical mark 5 cm (2 in.) below
the horizontal mark on the aiming
surface.
74
7. Adjust each headlight until correct
aim is obtained by turning the
adjuster clockwise to lower or
counterclockwise to raise the beam.

FUSES

The fuses are located in a power distri-
bution module in front of the steering
post under the electrical access panel.
If there is any type of electrical system
failure, always check the fuses first.
 NOTE: To remove the fuse, com-
press the locking tabs on either
ATV-0070
side of the fuse cover and lift out.
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat ATV dealer immediately.
ELECTRICAL OUTPUT
TERMINALS
Two output terminals for electrical
accessories are located on the front and
rear wiring harnesses. The accessory
plug is located on the front body panel.
KC0108A
0411-837