Out-Of-Range Alarm - Angelcare AC403 Owner's Manual

TO STOP THE ALARM
OR
Place your hand
back on the
mattress.
TO ADJUST THE SENSOR PAD SENSITIVITY LEVEL:
You can adjust the Nursery Unit
sensitivity dial to change your Sensor Pad
from less sensitive to very sensitive.
This sensitivity dial is located on the back
of the Nursery Unit.
NOTE:
If you are experiencing false alarms,
adjust the sensitivity level.
IMPORTANT
• The Sensor Pad is not designed for use with adults, children or infants older
than 24 months.
• Once you are finished using the Sensor Pad, please remove it from the baby's
crib and store it away.
5.4 - OUT OF RANGE SETTINGS
Your monitor has an Out-of-Range function that advises you when your two units
are not communicating. Out-of-Range situations can be caused by distance or
by physical interferences.
RANGE:
Approx up to 250 meters (open field)
18
OR
Shut the Nursery
Press
Unit OFF
any key
to put on
Hold (see
section 5.8)
For optimal results begin with the sensitivity
level dial on the 3 rd bar, adjusting the sensitivity
by half a bar increases or decreases as required.
TO ACTIVATE THIS FUNCTION:
ON
1
2
3
OFF

OUT-OF-RANGE ALARM

• Alarm activates when your two units are not communicating.
• The Parent Unit will emit a double beep every 8 seconds.
• Out of Range Icon will flash on the screen.
IMPORTANT
If the Out-of-Range function is activated and you turn the Nursery Unit OFF
the Out-of-Range Alarm will sound and/or vibrate (depending on the alarm mode
chosen). Turn the Nursery Unit ON again to reactivate the link.
TO STOP THE OUT-OF-RANGE ALARM:
Press 2 seconds
to turn the Parent
Unit OFF
5.5 - SOUND TRANSMISSION (VOX)
Your monitor is 'Sound Activated'. This means that it will transmit sounds only when it
detects them. It will detect even the softest levels of crying.
To save power, after 10 seconds, the sound transmission will stop if no sound is detected.
Once sound is detected transmission will automatically activate.
TO TEST SOUND:
Ask someone to speak into the Nursery
Unit or place the unit near a radio to ensure
that sound is being picked up.
IMPORTANT
To avoid feedback (whistling), keep both
units at least 3 meters apart.
1) Press MENU button 2 times.
The Out-of-Range Indicator
will blinks.
2) Using the UP and DOWN Arrows,
turn the function ON or OFF.
3) Press the SELECT button and then
EXIT to confirm your choice.
The Out-of range Icon will also flash
when channel is being changed or
the unit is reconnecting
Turn the Nursery
OR
Unit ON
IF YOU HEAR NO SOUND:
• Check that both units are switched ON.
• Check that both units are plugged into
functioning electrical outlets.
• Check the batteries in both units
(replace or recharge them as necessary
per unit).
• Bring the Parent Unit closer
to the Nursery Unit.
19