Fitting The Ceramics - Valor COSYFLAME TURBOCHIM 528 Owner's Manual

Fitting the ceramics

Place the front base coal in the burner compartment so that it rests on the ledges at the
sides and front. Pull the coal forward so that it is immediately behind the front rim of the
burner compartment. (See Fig 4 and 5).
Place the rear base coal in the burner
compartment behind the front coal. It should
rest on the ledge at the back of the burner
compartment and its rear face should touch the
rear ceramic wall (See figure 6 and 7).
Install the 9 loose coals as follows.
The smooth surfaces of the coals should be at
the bottom and back. Select the two smallest
coals and put them aside until all the other
coals are installed. Place four of the medium
size coals in the four valleys of the front coal.
Place the left side coal so that the customer
will be able to see the pilot flame. See figures 8
and 9.
Place the three remaining medium size coals
behind and approximately midway between
each of the coals in the front row. See figures
10 and 11.
Fig. 5
Fig. 7
Fig. 9
Fig. 11
7
Fig. 4
Fig. 6
Fig. 8
Fig. 10