Suzuki UF50 Service Manual page 51

3-22 ENGINE
Install the needle roller bearing using the special tool.
09924-84521: Bearing installer
NOTE:
Face the stamped side of the needle roller bearing out.
Apply SUZUKI SUPER GREASE "A" between the sliding sur-
face of the fixed driven face and movable driven face.
99000-25010: SUZUKI SUPER GREASE "A"
NOTE:
When installing the movable face to the fixed face, make sure
that the oil seal is positioned properly.
Install the pins 1 at three places on the drive face hub.
Apply sufficient SUZUKI SUPER GREASE "A" to the cam
where the pins are placed and to the surface of the driven
face, as shown.
99000-25010: SUZUKI SUPER GREASE "A"
Position the two O-rings 2.
Install the movable driven face spring guide.
NOTE:
Remove any grease from the movable driven face spring guide,
after installation.
Hold the clutch shoe assembly using the special tools and
then tighten the clutch shoe nut to the specified torque.
09930-40113: Rotor holder
09930-40131: Rotor holder attachment
Clutch shoe nut: 50 N·m (5.0 kgf-m)