Suzuki UF50 Service Manual page 49

3-20 ENGINE
Remove the bearing using the special tool.
09941-50111: Bearing remover
Replace the removed bearing with a new one.
Remove the oil seals 1 and O-rings 2.
Replace the removed oil seals and O-rings with new
ones.
CLUTCH SHOE
Inspect the clutch shoe for chips, cracks, uneven wear and burn-
ing. Check the thickness of the shoe using vernier calipers. If
any damages are found or if the thickness is less than the ser-
vice limit, replace the clutch shoe with a new one.
09900-20101: Vernier calipers
Clutch shoe thickness
Service Limit: 2.0 mm
Inspect the clutch spring for stretched or broken coils. If any dam-
ages are found, replace the clutch spring with a new one.
Replace the clutch shoe and clutch spring as a set.
Inspect the clutch housing surface for scrolling, cracks, or un-
even wear and measure the inside diameter of the clutch hous-
ing with inside calipers. Measure the diameter at several points
to check for out-of-round and wear. If any damages are found or
if the inside diameter exceeds the service limit, replace the clutch
housing with a new one.
Clutch housing I.D.
Service Limit: 110.50 mm