Replacing The Oven Lamp - Kenwood KS 100 G Instructions For Use - Installation Advice

Assembling and Dismantling of the Side Runner Frames
Fit the side runner frames into the holes on the side walls inside the oven (fig. 4.1).
−
Slide the drip pan and rack into the runners as shown in fig. 4.2.
−
The rack must be fitted so that the safety catch, which stops it sliding out, faces the


inside of the oven.
To dismantle, operate in reverse order.
−

Replacing the Oven Lamp

WARNING: Ensure the appliance is switched off before replacing the lamp to avoid
the possibility of electric shock.
Let the oven cavity and the heating elements to cool down.
−
Switch off the electrical supply.
−
Remove the protective cover "A" (fig. 4.3).
−
Unscrew and replace the bulb "B" with a new one suitable for high temperatures
−
(300°C) having the following specifications: 230V or 220-240V, E14 and same power
(check watt power as stamped in the bulb itself) of the replaced bulb.
Refit the protective cover "A".
−
Note: Oven bulb replacement is not covered by your guarantee.
Fig. 4.1
B
A
Fig. 4.2
Fig. 4.3
17