Kenwood KS 100 G Instructions For Use - Installation Advice page 10

Lighting of Gas Grill Burner
IMPORTANT: The oven door must be open during this operation.
To light the burner, you need to:
Fully open the oven door.
1
If this operation is not performed you should not proceed to light the oven.


2 Press the thermostat knob throughly to start up the electric ignition and, keeping the
knob under pressure turn it clockwise (fig. 2.5) to position
Never continue this operation for more than 15 seconds. If the burner has still


not ignited, wait for about 1 minute prior to repeating the ignition.


In case of mains failure, to light the grill manually, put a flame to the right and left side
of the burner (fig. 2.6), then press and turn the thermostat knob (fig. 2.5).
3. Wait about ten seconds after the burner lighting before releasing the knob (priming
time of the thermocouple).
4. Check that the burner has lit; if not, turn the knob anti-clockwise back to "
repeat the procedure from step 1.
5. The oven door must always be kept half-open when the grill is in operation.


For correct use see chapter "TRADITIONAL GRILLING".
If the flame extinguishes for any reason, the safety valve will automatically shut off the gas
supply to the burner.
To re-light the burner, first turn the grill control knob to OFF position "
1 minute and then repeat the lighting procedure.
IMPORTANT NOTE: It is not possible to use the fan motor in combination with the
gas grill; a safety device switches off the fan motor when the gas oven/grill control
knob is turned on grill position.
During and after use of the grill, certain parts will become very hot.
Keep children away.
ATTENTION: In case of manual lighting, never turn the thermostat before approa-
ching a flame to the burner.
10
Fig. 2.5
(fig. 2.2).
O
" (OFF) and
O
", wait for at least
Fig. 2.6