Before And After Charge Tests; Glow Plug Detection; System Saver - Midtronics PowerSensor Micro700 Instruction Manual

BEFORE AND AFTER CHARGE TESTS

If necessary, the analyzer will ask you if the battery has just been
charged. At the CHOOSE TEST prompt, select AFTER CHARGE or
BEFORE CHARGE and press ENTER.

GLOW PLUG DETECTION

If necessary during the Charging System Test, the analyzer will ask
you if the vehicle has glow plugs.
If you select NO, the analyzer concludes the test and displays the
charging system results. If you performed a Full System Test, press
ENTER to view the results.
If you select YES, the Micro700 begins a 40-second countdown.
The countdown allows post-heating of the glow plugs to finish so that
the Micro700 can properly evaluate the charging system. If post-
heating finishes within 40 seconds, the Charging System Test
continues.
If post-heating does not finish, the test is concluded and the charging
system results are displayed. If you conducted a full system test,
press ENTER to review the test results.

SYSTEM SAVER

When the analyzer's clamps are not connected to a battery or pack,
it will turn itself off after 20 seconds (except while printing) if it
detects you are not using the keypad. This helps prolong the life of
the analyzer's internal battery.
If the analyzer times out during a test, it will save the test sequence
and data. You can reactivate the analyzer by pressing the MENU
button or by reconnecting the battery clamps.
The analyzer will ask you if you want to continue the previous test.
If you select NO, the analyzer will return to the Options menu or to
the Test menu if the clamps were reconnected to the battery. If you
want to continue the test, reconnect the battery clamps and select
YES, then press ENTER.
13
• •