Replacing The Micro700 Battery - Midtronics PowerSensor Micro700 Instruction Manual

• Verify that a communications protocol selected in the printer
setup is compatible with the printer type selected in the Micro700
Options menu.
• If you are unable to print after ensuring the analyzer is
functioning, the printer is on, the battery is good, and the IR
transmitter and receiver are aligned, check the printer manual for
further instructions or call Midtronics at 800-776-1995 for
assistance.

REPLACING THE MICRO700 BATTERY

The Micro700 uses a 9-volt battery (alkaline recommended) to allow
testing of batteries down to 1 volt and supply power while the
Options menu is active. When the internal battery requires replacing,
the analyzer will display LOW INTERNAL BATTERY, REPLACE.
Change the battery as soon as possible.
NOTE: The analyzer will retain setup information while you change
the 9-volt battery.
IMPORTANT: The Micro700 can test down to 5.5 volts when the
internal 9-volt battery is not functioning.
1. Remove the cover to the battery door using a small screwdriver.
2. Insert a 9-volt battery. Make sure the positive and negative
terminals are positioned correctly.
3. Put the back cover and tighten the screw.
18
• •