Protecting Against Unauthorised Access; Resetting The Base To The Default Settings - Gigaset A510A User Manual

Base settings
After activating or deactivating the
repeater, switch your handset off and
on again (¢ page 22).
Please note
u Eco Mode / Eco Mode+ (¢ page 41)
and repeater support cancel each
other out i.e., if you use a repeater, you
cannot use Eco Mode or Eco Mode+.
u The default encrypted transmission
setting is deactivated when repeater
mode is activated.
Protecting against
unauthorised access
Protect the system settings of the base sta-
tion with a PIN known only to yourself. The
system PIN must be entered when, for exam-
ple, registering/de-registering a handset to/
from the base or when restoring the default
settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN that only you know.
Gigaset A510A: setting a system PIN enables
remote operation of the answering machine
¢ page 39.
¤ Settings ¤ System ¤ System PIN
§Menu§
~
Enter the current system PIN
and press
~
Enter your new system PIN and
§OK§
press
Resetting the system PIN
If you have forgotten your system PIN, you
can reset the PIN to the original code 0000
using the button on the base. This will also
reset other settings; see the section enti-
tled "Resetting the base to the default set-
tings".
48
§OK§
.
.
Resetting the base to the
default settings
When restoring default settings:
u Individual settings are reset
u All lists are deleted
u Eco Mode and Eco Mode+ are deacti-
vated
The date and time are retained.
Please note
The answering machine is ready for use
approx. 15 seconds after the base has
been connected or reset.
Resetting the base via the menu
When resetting via the menu
u Handsets are still registered
u The system PIN is not reset.
¤ Settings ¤ System ¤ Base Reset
§Menu§
§OK§
Press the display key.
Resetting the base using the
button on the base
When resetting the base using the button on
the base
u All handsets are de-registered and
u The system PIN is reset to the original
code 0000
Carry out the following steps:
¤ Remove the mains cable from the base
¤ Hold down the registration/paging key
on the base (¢ page 5) and reconnect
the power cable to the base at the same
time. Hold the key down for at least 5 sec-
onds.
Please note
All handsets are de-registered and must
be re-registered. All settings are reset to
the default settings.