Colour And Lighting Settings - Nokia N86 8MP User Manual

Extended digital zoom
●
available in the main
the zoom increments to be smooth and continuous
between digital and extended digital zoom,
(paused) allows the zoom increments to pause at the
digital and extended digital step point, and
a limited amount of zoom while retaining the image
resolution. Use the extended zoom only when getting
closer to the subject is more important than the final
image quality. The overall quality of a digitally zoomed
image is always lower than that of an unzoomed
image.
Capture tone — Set the tone that sounds when you
●
capture an image.
Memory in use — Select where to store your images.
●
Restore camera settings
●
settings to default values.

Colour and lighting settings

In the active toolbar, select from the following:
Flash mode ( ) (image only) — Select the desired
●
flash mode.
Colour tone ( ) — Select a colour effect.
●
Switch video light on
●
— Switch the video light on or off (video mode only).
42
— The setting is only
camera.On (continuous)
Off
— Restore the camera
or Switch video light off
White balance
●
allows
condition. This allows the camera to reproduce colours
more accurately.
On Exposure compensation
●
are shooting a dark subject against a very light
allows
background, such as snow, adjust the exposure to +1
or +2 to compensate for the background brightness.
For light subjects against a dark background, use -1 or
-2.
Sharpness
●
of the image.
Contrast
●
between the lightest and darkest parts of the image.
Light sensitivity
●
light sensitivity in low light conditions to avoid too
dark images.
The screen display changes to match the settings you
make.
The available settings vary depending on the selected
camera.
The setup settings are shooting-mode specific. Switching
between the modes does not reset the defined settings.
The setup settings return to the default settings when you
close the camera.
If you select a new scene, the colour and lighting settings
are replaced by the selected scene. You can change the
setup settings after selecting a scene if needed.
( ) — Select the current lighting
( ) (image only) — If you
( ) (image only) — Adjust the sharpness
( ) (image only) — Adjust the difference
( ) (image only) — Increase the
© 2009 Nokia. All rights reserved.