Extended digital zoom
●
available in the main
allows the zoom increments to be smooth and
continuous between digital and extended digital
zoom,
On (paused)
to pause at the digital and extended digital step
point, and
Off
allows a limited amount of zoom
while retaining the image resolution. Use the
extended zoom only when getting closer to the
subject is more important than the final image
quality. The overall quality of a digitally zoomed
image is always lower than that of an unzoomed
image.
Capture tone
— Set the tone that sounds when
●
you capture an image.
Memory in use
●
images.
Restore camera settings
●
settings to default values.
Colour and lighting settings
In the active toolbar, select from the following:
Flash mode
( ) (image only) — Select the
●
desired flash mode.
Colour tone
( ) — Select a colour effect.
●
Switch video light on
●
— Switch the video light on or off (video mode
only).
84
— The setting is only
camera.On (continuous)
allows the zoom increments
— Select where to store your
— Restore the camera
or
Switch video light off
White balance
( ) — Select the current
●
lighting condition. This allows the camera to
reproduce colours more accurately.
Exposure compensation
●
you are shooting a dark subject against a very
light background, such as snow, adjust the
exposure to +1 or +2 to compensate for the
background brightness. For light subjects
against a dark background, use -1 or -2.
Sharpness
( ) (image only) — Adjust the
●
sharpness of the image.
Contrast
( ) (image only) — Adjust the
●
difference between the lightest and darkest
parts of the image.
Light sensitivity
( ) (image only) — Increase
●
the light sensitivity in low light conditions to
avoid too dark images.
The screen display changes to match the settings
you make.
The available settings vary depending on the
selected camera.
The setup settings are shooting-mode specific.
Switching between the modes does not reset the
defined settings.
The setup settings return to the default settings
when you close the camera.
If you select a new scene, the colour and lighting
settings are replaced by the selected scene. You can
( ) (image only) — If