Making Calls Using Ip Addresses - Grandstream Networks GXP1610 User Manual


When dial out via paging, user can see the "call-info" header contains "answer-after=0" and "the "alert-
info" header contains "info=alert-autoanswer;delay=0" in the outgoing INVITE.

MAKING CALLS USING IP ADDRESSES

Direct IP Call allows two phones to talk to each other in an ad-hoc fashion without a SIP proxy. VoIP calls
can be made between two phones if:

Both phones have public IP addresses; or

Both phones are on the same LAN/VPN using private or public IP addresses; or

Both phones can be connected through a router using public or private IP addresses (with necessary
port forwarding or DMZ).
To make a direct IP call, please follow the steps below:

Press MENU button to bring up main menu;

Select "Direct IP Call" using the navigation arrow keys;

Press MENU to enter the Direct IP Call mode;

Input the 12-digit target IP address (Please see example below);

Press the "More" softkey to make sure the softkey selection "IPv4" or "IPv6" is correctly selected
depending on your network environment;

Press "OK" softkey to dial.
For example:
If the target IP address is 192.168.1.60 and the port is 5062 (i.e., 192.168.1.60:5062), input the following:
192*168*1*60#5062. The * key represents the dot (.), the # key represents colon (:). Wait for about 4
seconds and the phone will initiate the call.
Quick IP Call Mode:
The GXP1610/GXP1620/GXP1625/GXP1628 also supports Quick IP Call mode. This enables the phone
to make direct IP calls using only the last few digits (last octet) of the target phone's IP address. This is
possible only if both phones are under the same LAN/VPN. This simulates a PBX function using the
CSMA/CD without a SIP server. Controlled static IP usage is recommended.
To enable Quick IP Call Mode, go to phone's Web GUI->Settings->Call Features, set "Use Quick IP - call
mode" to "Yes". Clicking on "Save and Apply" on the bottom of Web GUI page to take the change. To make
Quick IP Call, take the phone off hook first. Then dial #xxx where x is 0-9 and xxx<255. Press # or SEND
GXP1610/GXP1620/GXP1625/GXP1628 User Guide Page 24 of 35