Motorola DS6878 Product Reference Manual page 46

2 - 4 DS6878 Product Reference Guide
NOTE If the scanner was previously unpowered and the LED indicator light is solid red, the scanner is in
pre-charge mode. It is normal for pre-charge mode to last several seconds while the scanner powers up,
however it can last several minutes if the battery has significantly discharged due to excessive use or
storage. If the solid red LED condition persists, there may be a problem with the battery or the scanner, in
which case discontinue use of the scanner and contact Motorola Solutions support.
Scanner LED Definitions with CR0078-P Cradle
Table 2-3
LED
Green Solid
Red Solid
CR0078-S/CR0008-S Cradle LED Definitions
Table 2-4
LED
Green Solid
Green Flash
Red Flash
CR0078-P Cradle LED Definitions
Table 2-5
LED
Green Solid
Green Flash
Red Flash
Red Solid
Blue Solid
Amber Flash
Blinks off for a decode then turns solid green until the next decode.
Communication error with cradle.
Cradle is powered.
Cradle is externally powered with a USB host interface that suspended the
cradle. The cradle is no longer connected to the digital scanner but charges the
digital scanner. Scan the pairing bar code to pair the scanner and cradle (see
Pairing on page 4-22).
Transmission error.
Cradle is powered (scanner not in cradle).
Fully charged scanner (scanner in cradle).
Charging scanner (scanner in cradle).
Transmission error.
Charge error (scanner in cradle).
When Page Button is enabled and pressed (see
the cradle LED turns blue when the scanner is out of the cradle.
Critical battery temperature fault. Battery is above or below normal operating
temperature.
If this occurs, do not use the digital scanner and move the digital scanner to a
location within normal operating temperature. The digital scanner can remain in
the cradle while the battery warms or cools to normal operating temperature.
Note: For appropriate charging temperatures, see
Indication
Indication
Indication
Page Button on page
Table 3-3 on page
4-28),
3-10.