Led Definitions - Motorola DS6878 Product Reference Manual

Standard Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Host Specific
USB only
Four high beeps
Digital scanner gives a power-up beep after
scanning a USB Device Type.
This power-up beep occurs more than once.
RS-232 only
High beep

LED Definitions

In addition to beeper sequences, the digital scanner communicates with the user using a two-color LED
display. Table 2-2
Scanner LED Definitions with CR0078-S Cradle
Table 2-2
LED
Scanning
Green Flash
Red Solid
Charging
Green - Slow Continuous Flash
Green - Fast Continuous Flash
Green Solid
Red Solid
Amber Flash
Digital scanner has not completed initialization. Wait several
seconds and scan again.
Communication with the bus must be established before the digital
scanner can operate at the highest power level.
The USB bus may put the digital scanner in a state where power to
the digital scanner is cycled on and off more than once. This is
normal and usually happens when the host PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled
(Point-to-Point mode only).
defines LED colors that display during scanning.
A bar code was successfully decoded.
Transmission error or digital scanner malfunction.
Non-critical battery temperature fault. Battery is above or below normal
operating temperature.
If this occurs, do not use the digital scanner and move the digital scanner to a
location within normal operating temperature. The digital scanner can remain in
the cradle while the battery warms or cools to normal operating temperature.
Note: For appropriate charging temperatures, see
Digital scanner is charging.
Digital scanner is fully charged.
Scanner is in pre-charge, charge error or communications error with cradle.
Critical battery temperature fault. Battery is above or below normal operating
temperature.
If this occurs, do not use the digital scanner and move the digital scanner to a
location within normal operating temperature. The digital scanner can remain in
the cradle while the battery warms or cools to normal operating temperature.
Note: For appropriate charging temperatures, see
Indication
Indication
Table 3-3 on page
Table 3-3 on page
Scanning 2 - 3
3-10.
3-10.