Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis
4. Disconnect the data and power cables from the back of the drive
5. Remove the four guide screws (two on each side) from the old drive. You will need these
screws to install a new drive.
6. Store the removed drive in anti-static packaging.
To install a drive, reverse the removal procedure.
After seating the drive in the drive cage, make sure the power connector is fully seated. It may be
necessary to move the power cable a bit to ensure that it does not pull the connector partially out
of its socket.
8–14
336492-003
Service Reference Guide