7.3
Hood Sensor
1. Prepare the computer for disassembly (Section 7.1).
2. Remove the computer access panel (Section 7.5).
3. Remove the front bezel (Section 7.6).
4. Raise the drive cage to its upright position 1.
5. Slide the hood sensor switch towards the inside of the computer 2.
6. Disconnect the hood sensor cable from the system board 3.
To install the hood sensor, reverse the removal procedure.
Service Reference Guide, d500
Removal and Replacement Procedures - Small Form Factor (SFF) Chassis
336492-003
7–3