7. Slide the bracket on the end of the expansion card down into the slot 1 and press the card
firmly into the socket.
When you install an expansion card, make sure you press firmly on the card so that the whole
connector seats properly in the expansion card socket on the system board.
8. Close the latch firmly to secure the card in place 2.
9. Connect external cables to the installed card as needed.
10. Replace the bottom access panel.
11. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide on
the Documentation Library CD for instructions about using Computer Setup.
Service Reference Guide
Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis
336492-003
8–11