Cabling - Toshiba SD-M1401 Hardware Instruction Manual

CABLING

SCSI - The internal SCSI interface cable is connected to your SCSI
host adapter card and fits into the socket on the back of your DVD-
ROM. The stripe side (or red-colored side) of the ribbon cable con-
nects to pin 1 on the drive's SCSI connector which is found next to the
drive's power connector. Carefully push the SCSI connector into the
socket, making sure it fits snugly.
Power - Apply power to your DVD-ROM by connecting your
computer's power cable to the power socket at the back of the drive.
One side of the plug has chamfered edges, so the power connector fits
only one way. Push plug completely into the socket making sure the
plug fits into the socket correctly.
Severe damage to the DVD-ROM circuits may occur if power cable
is plugged in upside-down.
If there is no power cable in your system, contact your computer dealer.
You may need a "power splitter lead" (a Y shaped cable which taps
two power outputs from one input).
8
TOSHIBA SD-M1401 DVD-ROM Drive
Attaching SCSI Cable
CAUTION!