Toshiba SD-M1401 Hardware Instruction Manual page 15

Daisy-Chaining - If the DVD-ROM you are installing is one of two
or more SCSI devices you have connected to your system, you will
need to use a custom built SCSI interface cable. Remember that the
terminator jumper on the DVD-ROM drive must have the jumper in-
stalled when the drive is the last device in the chain.
Host Computer
Host Computer
SD-M1401 DAISY-CHAIN CONNECTION
Notes:
1. Terminator jumper must be jumpered when DVD-ROM is the last
or only device on the SCSI BUS.
2. Terminator jumper should be removed when DVD is in a "daisy-chain"
and is NOT the last drive.
10
TOSHIBA SD-M1401 DVD-ROM Drive
I/F Card
SCSI Cable
Terminator
SD-M1401 CONNECTION (ONE DRIVE)
SCSI Cable
I/F Card
Terminator
If connecting more
than three SCSI
devices, you need to
use a custom built
SCSI Interface Cable.
Interface
Connector
(see note 1)
SD-M1401
INTERNAL DRIVE(S)
Interface Connector
DVD-ROM
DRIVE
#1
(see note 2)
DVD-ROM
DRIVE
#2
(see note 2)
DVD-ROM
DRIVE
#N
(N < 7)
Install Terminator Jumper
only on the last drive of BUS
(see note 1)
(MULTIPLE DRIVES)
DVD-ROM
DRIVE