Convergent Design Odyssey7Q Setup Manual page 21

FS700 Post Production
The media pool CameraRaw settings are the same as the ones in the color page and these are
designed for individual clip adjustment so its better to first set the 'project settings', 'camera
raw' as you need for the whole project.
Select 'Project Settings', 'Camera Raw', 'Cinema DNG' and make sure the 'Decode using' is set to
either 'CinemaDNG Default' or "Camera Metadata'
The "Camera Metadata' is the default and the best place to start if you need to change an
individual clip with camera raw.
The Media pool settings are helpful if you have a mix of different clip types, you can sort by
codec, select a group and adjust.
For you Convince Convergent Design has Generated several example LUT's that can be applied
to your RAW footage. Keep in mind these LUTs are an approximation, and may need adjusting
depending on your application.
These LUTs are available in the Firmware/Downloads section of the Convergent Design website.
*Also note that using camera metadata or CinameDNG default is also supported.
TO LOAD 3D LUT'S INTO DAVINCI RESOLVE
1. Select the Project Settings wheel, and navigate to Look up Tables
2. Select Open LUT Folder, and copy the included example LUTS into this folder.
3. Now Select Update Lists
4. Now in the media Browser you can right click on your raw file and select 3D LUT and select
the LUT you wish to apply from the list.
Note the following about each CD example LUT, and you should adjust the LUT based on your
application.
FS700_1.11.100_SLOG.cube
This Lut can be applied to view a simulated SLOG2 look. based on the raw recording with the
SLOG2 picture profile, also note the image should closely match the internal media.
( Continued on Next Page » )
Convergent Design, Inc.
4525 Northpark Dr. | Colorado Springs, CO 80918 | USA
TEL: ++ (720) 221-3861 | FAX: ++ (720) 227-9296 | Office Hours: 8:00 A.M. to 5:30 P.M., Monday – Friday [Mountain Time (GMT – 7)]
EMAIL: CDSupport@Convergent-Design.com | WEBSITE: www.Convergent-Design.com
(Continued)
21