Table of Contents
Advertisement
Table 6.4 - Door Latch and Magnet Sensor Assemblies Parts List
ITEM
QTY.
DESCRIPTION
1
1
Door Latch
2
1
Door Sensor (Magnetic Reed Switch)
3
1
Door Sensor Mounting Bracket
4
2
Door Sensor Spacer ( 6-32 hex nut, zinc plated)
5
2
Spring
6
4
Washer, Nylon
7
2
4-40 Hex Nut, with Nylon insert, zinc plated
8
2
4-40 Slotted Pan Head Machine Screw, zinc plated, 3/8" long
9
2
6-32 Hex Nut with Nylon insert, zinc plated
10
2
6-32 Slotted Pan Head Machine Screw, zinc plated, 1/2" long
2
10-32 Nut with nylon insert, zinc plated
The cooking compartment door handle tension is
preset at the factory during assembly, and should not need
adjustment. Should the door handle tension need adjustment,
the procedure is as follows:
Procedure:
I. Open the cooking compartment door.
2. Remove the 6 screws, 3 from the top edge and 3 from
the bottom edge of the door.
3. Remove the door gasket, door gasket
mounting plate and door insert from the door.
.
MARKET FORGE INDUSTR IES
INC
35 GARVEY
EVERETT, MA 02149
STREET
TEL-617 387 4100 TELEX: 94-94 I 4
FAX 6173874456 OUTSIDE MA 800 227 2659
6. Maintenance
.
6.13
Do not disassemble these three components, remove
them as an assembly.
4. Tighten both nuts down until the springs are fully
compressed.
5. Back each nut off 5 turns.
6. Replace the door gasket, mounting plate and insert
assembly.
7. Remount the large side panel.
PART NO.
E91-5746
E08-6308
E91-5697
El 0-2331
E08-4600
E10-0100
E08-3845
E08-3496
E08-3838
E08-3484
E08-3841
Advertisement
Table of Contents
