Table of Contents
Advertisement
The cooking compartment door alignment, door
handle tension and latch tension are pre-adjusted at
the factory during assembly. During normal usage,
these should not need any attention.
Note that when the cooking compartment doors
are reversed, as described in Section 2.5 , the doors
will need to be aligned and the door latch tension will
need to be adjusted (the door handle will not need
adjustment when the door is reversed).
6.8.1 Door Alignment
The cooking compartment doors are pre-aligned
at the factory during assembly, and should not need
adjusting unless they are reversed. Should the doors
need realignment, the procedure is as follows:
Procedure:
1. Open the cooking compartment door.
2. Loosen all 4 bolts (2 per hinge) which mount the
upper and lower hinge brackets to the face of
the unit using a 5/16" wrench. DO NOT
REMOVE THE BOLTS.
3. Begin to retighten all 4 bolts so that they are snug
against the face of the unit. DO NOT
COMPLETELY TIGHTEN THE BOLTS.
4. Slowly, ease the cooking compartment door
dosed until it is latched.
5. The cooking compartment door can now be
raised, lowered, and/or rotated into position by
bumping it with the palm of your hand or by
using a small rubber mallet.
6. First, check the alignment at the front of the door
by making sure that the striker in the door is
centered, with the latch mechanism on the front
of the unit.
7. Square the door to the unit by raising or
MARKET FORGE INDUSTRIES, INC.
35 GARVEY STREET
, MA 02149
EVERETT
TEL: 617 387 4100 TELEX: 94-94 1 4
FAX: 6 17 387 4450 OUTSIDE MA 800 227 2859
6. Maintenance
8. Visually inspect the door. Be sure that the door is square
9. Gently open the cooking compartment door, taking care
10. Tighten all 4 door hinge bracket mounting bolts, using
11. Clos
6.8.2 Door Latch Tension Adjustment
preset at the factory, and should not need adjusting
unless the doors are reversed. Should the latch need
adjustment, the procedure is as follows:
Procedure:
1. Open the cooking compartment door.
2. If latch is mounted on the right side of the cooking
3. Tighten both nuts down until the springs are fully
4. Back each nut off 1/2 turn.
5. Remount the control panel or left side panel.
6.12
lowering the hinge side of the door, keeping the latch
centered with the striker.
to the unit, the striker is centered with the latch, and
the gasket is in contact with the entire lip of the
cooking compartment.
not to move it out of position.
a 5/16" wrench.
e
and visually inspect the door again, as described
in step 8.
The cooking compartment door latch tension is
compartment, remove the corresponding control
panel. If latch is mounted on the left side of the
cooking compartment, remove left side panel.
compressed.
Advertisement
Table of Contents
