Table of Contents
Advertisement
The following sections set forth minimum
preventive maintenance procedures which must be
completed periodically to assure continued trouble free
operation.
6.4 CLEANING THE GENERATOR
The Steam Tech Plus Pressureless Steam
Cooker has an automatic indicator light which tells you
when the steam generator needs to be cleaned. When
the CLEAN GENERATOR light comes on, the
generator remains fully functional until it is shut down.
This will allow you to continue to use the unit for the
remainder of the day, until you shut it down. The next
time the unit is turned on, the generator will fill and
preheat to 190°F, but it will not create steam. The
CLEAN GENERATOR light will remain illuminated. The
steam generator must be cleaned before it will create
steam again.
6.4.1 Cleaning Instructions
These cleaning instructions can also be found
printed on the sticker, on the top of the electrical box
inside the unit.
In order to perform this procedure, you will need
TOTAL CONCEPT™ de-liming solution. (Market Forge
Pan Number 20-0307.)
Procedure:
1. Leave the POWER switch on, and wait for the
green READY light.
2. Remove the right pan support rack from inside the
cooking compartment to reveal the side wall
opening
CAUTION: The steam generator and pipe
fittings reach 190°F during the preheat cycle.
Use caution and wear
, Inc.
MARKET FORGE INDUSTRIES
35 GARVEY STREET EVERETT, MA 02149
TEL: 017 387 4100 TELEX: 94-94 1 4
FAX: 61 7 387 4456 OUTSIDE MA 800 227 2659
6. Maintenance
6.3
protective hand covering. DO NOT TRY TO
REACH INTO THE OPEN SIDE WALL PORTS
This opening is directly connected to the
steam generator.
3. Pour 1/2 gallon of Market Forge's TOTAL CON-
CEPT™ de-liming solution directly into the open
side wall port. This will immerse the generator
interior and water level probes in the solution.
CAUTION: Read directions and information on
TOTAL CONCEPT™ de-liming solution before using.
4. Wait two hours for TOTAL CONCEPT™ de-liming
solution to work. (Other de-liming solutions may
take much longer.)
5. Make sure the cooking compartment door is
unlatched and slightly ajar, then press the
RINSE & DRAIN button for the generator being
cleaned. (The RINSE & DRAIN buttons are
located on the front of the electrical box, inside
the unit. See Figure 6.1 on page 6.2)
This will start the draining and spray rinsing of the
steam generator. The RINSE & DRAIN cycle will run for
approximately 3 minutes. At the end of the RINSE &
DRAIN cycle, the steam generator will automatically
refill and warm up.
IT IS NOT NECESSARY TO RINSE & DRAIN
MORE THAN ONCE. The rinsing spray inside the
steam generator will remove all traces of the de-liming
solution.
NOTE: When the steam generator is clean, the
CLEAN GENERATOR light will go off as soon as the
green READY light comes on.
CAUTION: If, after cleaning the steam generator, the
CLEAN GENERATOR light is still on after warm-up
(when the READY light comes on), there may be an
electrical problem. See page 5.5 of the Troubleshooting
section of this manual. Consult with qualified service
personnel for test and repair.
Advertisement
Table of Contents
