Table of Contents
Advertisement
4.3 DAILY CLEANING
After each period of daily operation (more frequently as
required to maintain cleanliness) the cooker should be
thoroughly cleaned by completing the following steps:
1. Remove the left and right side pan support racks by
lifting them up off their mounting brackets.
2. Remove the a-la-carte tray from the floor of the
cooking compartment by lifting the front of the tray
off the mounting pins and sliding it forward.
3. Remove the drain screen from the rear wall of the
cooking cavity by sliding it up off its mounting tabs.
4. Wash cooking compartment interior using detergent
and water. Rinse and dry thoroughly.
5. Remove upper and lower Drip/Spill Trough screens.
Lift the left side of the screen up and swing it out
away from the face of the unit until it Is free to slide
out from under the control panel housing.
6. Wash all removed pieces with a detergent, using a
brush, and rinse. These pieces can also be sent
through a commercial automatic dishwashing
machine. Set these pieces aside for reassembly.
7. Replace the Drip/Spill Trough screens by sliding the
right hand side of the screens under the control
panel housing. Then swing the left hand side of the
screen in towards the face of the unit until the
screen is free to drop down into position.
8. Replace drain screen onto rear wall of cooking
compartment by sliding it down onto its mounting
tabs.
,
MARKET FORGE INDUSTR IES
INC
35 GARVEY STREET EVERETT, MA 02149
TEL: 617 387 4100 TELEX: 94-9414
FAX: 017 387 4456
MA 800 227 2659
OUTSIDE
4. Operation
.
9. Replace a-la-carte tray by sliding it back until it drops
down onto its mounting pins.
10. Replace pan supports into cooking cavity by
hanging them on their mounting brackets. 8e sure
to hang the support with the metal baffling on it on
the right (steam inlet opening) side of the cooking
cavity.
4.4 PROLONGED SHUT-DOWN AND CLEANING
1. Press the both POWER switches into the OFF position. The
steam generators and tempering tank will automatically
drain.
2. Clean the cooking compartment, as described in Section
4.3 of this manual.
3. The Steam Generator must be Rinsed & Drained. Refer to
Section 6.4, Cleaning the Generator, for complete
instructions.
4. Turn gas valve to the OFF position.
CAUTION:
• Disconnect the power supply to the steam generators
before servicing.
• Keep appliance area free & clear from combustibles.
• Don't obstruct the flow of combustion & ventilation air.
• Contact the factory, the factory representative, or a factory
authorized service company to preform maintenence and
repairs.
• In the event of a power failure, no attempt should be made
to operate this appliance. Be sure both power switches are
in the OFF position.
• Keep this manual for daily reference.
4.5
Advertisement
Table of Contents
