Reversing The Doors - Market Forge Industries STP-6G Installation And Operation Manual

2.5 REVERSING THE DOORS

The Steam Tech Plus Pressureless Steam
Cooker has cooking compartment doors which are
reversible, for your convenience. For Door Assembly
illustration and table, refer to pages 6.14 and 6.15.
NOTE: This procedure is identical for both the
upper and lower cooking compartment doors.
1. Remove the left large side panel by removing the
screw from the center of the bottom edge of the
panel. Gripping one of the louvers, slide the
panel upwards until the bottom edge of the panel
is free to swing out slightly away from the unit.
Slide the panel down until its top edge is dear of
the top cap of the unit.
2. Open Cooking Compartment door.
3. Remove the two 5/16" bolts that attach the top
hinge to the front of the unit.
4. Slide the door upwards, off the bottom hinge.
5. Remove the two 5/16" bolts that attach the bottom
hinge to the front of the unit.
NOTE: The top hinge is slightly larger than
the bottom hinge.
6. Remove the 4 black plastic hole plugs from the
front of the unit. Push the black hole plugs into
the now vacant left upper and lower hinge
mounting holes.
7. Reinstall the top (larger) hinge and bolts into the
right lower hinge mounting holes. Rotate the
hinge 180° for installation, so that the pin
which the door rides on is now facing up. The
hinge must be rotated because it will now
function as the bottom hinge. DO NOT
COMPLETELY TIGHTEN THE HINGE
MOUNTING BOLTS YET These will be used
later for adjusting the door.
MARKET INDUSTRIES, INC.
FORGE
35 GARVEY STREET EVERETT , MA 02149
TEL: 617 387 4100 TELEX: 94-94 1 4
FAX: 0 1 7 387 4456 OUTSIDE MA 800 227 2659
2. Installation
2.5
8. Remove the door latch assembly from the
face of the unit. The 2 door latch mounting nuts
are located behind the face of the unit and must
be accessed by removing the large side panels.
9. Remove the two white hole plugs from the left
door latch mounting holes, and insert them into
the right door latch mounting holes (where the
door latch assembly was originally mounted).
10. Rotate the door latch assembly 180°, and
install into the left door latch mounting holes.
NOTE: Each stud on the latch assembly should
have a plastic washer, a spring, a plastic washer
and a Nyloc type nut, as shown In Figure 6.5 on
page 6.14.
11. To adjust the tension of the door latch, tighten
both nuts down until the springs are fully
compressed, then back each nut off 1/2 turn.
12. Replace large side panel by placing the panel
against the side of the unit. Be sure that the top
edge of the side panel slides under the top cap
of the unit. Slide the panel upwards until it stops.
Then, while pushing the panel in towards the
unit, slide it down into position. Replace screw.
13. Rotate the door 180° for mounting.
14. Slide the remaining (small) hinge into the top
door bearing.
15. Slide the door and hinge assembly down onto
the hinge which you have already mounted to
the front of the unit. Use the two 5/16" bolts to
mount the top hinge into the right upper hinge
mounting holes. DO NOT COMPLETELY
TIGHTEN THE HINGE MOUNTING BOLTS
YET. These are used later for door adjustment.
16. Door Adjustment is covered in Section 6.8 on
page 6.12 of this manual.