Overall And Recess Dimensions; Installation Procedure; General Instructions - Dometic DMC 7-Series Installation & Operating Instructions Manual

overall anD recess DiMensions

MoDel
Data
OveRAll DIMeNSIONS
Height (A) mm
inches
Width (B) mm
inches
Depth (C) mm
inches
ReCeSS DIMeNSIONS
Height (H) mm
inches
Width (W) mm
inches
Depth (D) mm
inches

installation proceDure

general instructions

• Make sure the floor is solid and level.
• Do not install the appliance directly on carpeting. Carpet-
ing must be removed or protected by a metal or wood panel
beneath the appliance, which extends at least full width and
depth of the appliance.
• The refrigerator must be level and installed in a substantial
enclosure.
installing anD securing the
refrigerator
When installing the refrigerator in the enclosure, all areas with-
in the recess have to be sealed. Verify that there is a complete
seal between the front frame of the refrigerator and the top,
sides and bottom of the enclosure. A length of sealing strip is
applied to the rear surface of the front frame for this purpose.
The sealing strip should provide a complete isolation of the
appliance's combustion system from the vehicle interior.
DMr/DMc
1391
54-3/4
637
25-5/64
668
26-19/64
1365
53-3/4
602
23-11/16
616
24-1/4
Be careful not to damage the
sealing strip when the
refrigerator is put in place!
Side view
D
H
A wood strip must be in place across the upper
opening of the enclosure. The top frame of the
refrigerator will be anchored to the wood strip
with screws.
After the refrigerator has been installed (ensuring a combustion
seal at the front frame), the refrigerator must be secured in the
enclosure with five screws (not included). Furthermore, a lower
front strip (shipped as a loose part) should be attached.
NOTe! It is important to follow the sequence in securing
the refrigerator since failure in doing that can cause leakage
between the frame and cabinet!
Install the five screws in the following order:
1. Two screws installed through the front base and
installation of the lower front strip.
a) Install the lower front strip by sliding it under the
bottom hinge plate. The hinge plate can be on the
right or left side depending on the door swing.
Once the lower front strip is slipped under the
hinge, the part is possible to swing into place.
- 6 -
view from above
C
A
D
W
B
C
A
Wood strip