Table of Contents
Advertisement
DIMENSIONS
The following dimensions offer adequate space for service
and proper installation.
OVERALL DIMENSIONS
Height
Width
Depth
A
B
inch 30-5/32
21-7/8 22-23/32 29-3/4
mm
766
556
S
d i
e
D
H
V
e i
w
D
W
INSTALLING THE REFRIGERATOR
• It is essential that all maximum or minimum dimensions
are strictly maintained, as the performance of the refrig-
erator is dependent on adequate flow of air over the rear of
the refrigerator. The refrigerator must be installed in a sub-
stantial enclosure and must be level, see "
• Note! Do not install the appliance directly on carpeting.
Carpeting must be removed or protected by a metal or
wood panel beneath the appliance, which extends at least
full width and depth of the appliance.
• The space between the storage cabinet and the top of the
refrigerator should be blocked otherwise heat will become
trapped in this space, making the top of the refrigera-
tor hot, thus reducing the efficiency of the unit. All areas
within the recess in which the refrigerator is installed must
be sealed:
- Make sure that there is a complete seal between the
front frame of the refrigerator and the top, sides and bot-
tom of the enclosure. A length of sealing strip is applied
to the rear surface of the front frame for this purpose.
RECESS DIMENSIONS
Height
Width
Depth
C
H
W
20-1/2
577
756
521
v
e i
w
A
f
o r
m
a
b
o
v
e
B
C
DIMENSIONS
- Apply a sealing strip
to the foremost floor
of the enclosure. The
sealing should provide a
complete isolation of the
appliance's combustion
system from the vehicle
interior.
D
21-3/8
Note! Be careful not to damage the sealing strip when
542
the refrigerator is put in place.
SECURING THE REFRIGERATOR
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and cabinet!
After the refrigerator is put in place, (insuring a combustion
seal at the front frame), the refrigerator is to be secured in the
enclosure with five screws (not included).
The screws have to be installed in the following order:
1. Four screws installed through the front frame.
2. One screw installed in rear base.
In the parts bag there are plugs to be snapped in
the front frame to cover the four screw heads.
1
".
CONNECTIONS
UNIVERSAL LP GAS CONNECTION
The gas installation and servicing must be carried out by an
authorised person and conform to all relevant local authori-
ties.
The refrigerator is not designed for operation on town gas or
natural gas but for operation on universal LP gas, the pres-
sure of which must be 2,75 kPa. Check that this is stated on
the data plate. The gas supply system must incorporate an
approved gas pressure regulator to maintain a supply pressure
of 2,75 kPa.
Check that the gas supplied to the refrigerator is at the
correct pressure.
4
CAUTION
2
Advertisement
Table of Contents
