Mounting Instructions; Panel Dimensions; Reversing The Door Swing - Dometic DMC 7-Series Installation & Operating Instructions Manual

Mounting instructions

Mounting the Door hanDles
To mount the handles, follow these steps:
1. Snap on the handle by inserting its tabs in the slot
and slide into place.

reversing the Door swing

The refrigerator is equipped with hinges that makes it possible
to change the direction the door opens by moving the hinges
pins to the opposite side. For additional information, please
contact service point or distributor service dept. for assistance.
installing the Door panels
The refrigerator is delivered without door panels. Before start-
ing the mounting work, read this instruction thoroughly and
check that the panel dimensions are in compliance with those
given in the table below.

panel DiMensions

Max. thickness 5/32" (4 MM)
Model
max
DMR
upper inch 16,57
421
mm
lower 34,68
inch
881
mm
DMC
16,57
inch
421
mm
lower inch 34,68
881
mm
To install the door panel, follow these steps:
1. Remove the decoration strip by inserting a finger in
the plastic profile and pull.
- 9 -
height width
min max
16,5 23,7
419 602
34,61 23,7
879 602
16,5 23,74
419 603
34,61 23,74
879 603
min
23,6
600
23,6
600
23,66
601
23,66
601