Wiring The Power Inputs - Planet ISW-504PT User Manual

2.1.4 Wiring the Power Inputs

The 6-contact terminal block connector on the top panel of Industrial
Fast Ethernet Switch is used for two DC redundant powers input. Please
follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2
for POWER 1, or 5 and 6 for POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
The wire gauge for the terminal block should be in the
range between 12 ~ 24 AWG.
Note
14
V1- V1+ V2- V2+
PWR1 Fault PWR2
V1- V1+ V2 - V2+
1 2 3
Power 1 Fault
- +
Input
DC 24V/48V
4 5 6
Power 2
- +