Introduction; General Safety Information - Custom Audio Electronics s’print DPT100-B User Manual

INTRODUCTION

MANUAL ORGANIZATION
In addition to the Introduction which includes a description of the explanatory notes used in the manual,
general safety information, how to unpack the printer and a brief description of the printer including its basic
features, this manual is organized as follows:
Chapter 1: Contains the information required for correct printer installation and its proper use, as well as
interface specifications
Chapter 2: Contains information on interface specifications
Chapter 3: Contains a description of the printer command set
Chapter 4: Contains Technical Specifications of the printer
Chapter 5: Contains the character sets (fonts) used by the printer
SYMBOL USED IN THIS MANUAL
NOTE. Gives important information or suggestions relative to the use of the printer.
WARNING
Information marked with this symbol must be carefully followed to guard against damaging the
printer.
DANGER
Information marked with this symbol must be carefully followed to guard against operator injury or
damage.

GENERAL SAFETY INFORMATION

•
Read and keep the instructions which follow.
•
Before cleaning the printer, disconnect the power supply and make sure that the printer is off.
•
Clean the printer with a damp cloth. Do not use liquid or spray products.
•
Do not operate the printer near water.
•
Only use approved accessories and batteries. Do not connect to products that are not compatible.
•
Use the type of electrical power supply indicated on the printer label. If in doubt, contact your retailer.
•
When deciding where to place the printer, make sure it is positioned where its cables will not be
damaged.
•
Do not introduce foreign objects of any kind into the printer as they could cause a short circuit and could
jeopardize printer functioning.
•
Do not spill liquids onto the printer.
•
Do not carry out technical operations on the printer, with the exception of the scheduled maintenance
procedures specifically indicated in the user manual.
•
Disconnect the printer from the electricity supply and have it repaired by a specialized technician when:
A. The feed connector has been damaged.
B. Liquid has seeped inside of the printer.
C. The printer has been exposed to rain or water.
D. The printer is not functioning normally despite the fact that all instructions in the users manual
have been followed.
E. The printer has been dropped and its outer casing damaged.
F. Printer performance is poor.
G. The printer is not functioning.
1
DPT100-B/I/BT