Installing Accessories; Installing Sandpaper - 909 OSC400 Instruction Manual

Installing accessories

All accessories are installed on the oscillating tool in
a similar manner. For the purposes of describing the
accessory installation, the plunge cutting blade is used.
DANGER: Always remove the plug from the power source
before installing or removing accessories or sandpaper.
Failing to remove the plug from the power source may result
in the tool accidentally being started and causing serious
injury to the operator.
1. Remove the screw and washer from the accessory holder
by turning the screw counter clockwise. Use the 5mm hex
key if the screw is too tight to be removed by hand.
2. Place the blade on the accessory holder.
Notes:
a) Make sure the alignment holes in the blade fit over the
alignment pins in the accessory holder and the printed
side of the blade is facing the tool.
b) The blade can be mounted at various angles left or
right of centre if required.
3. Thread the screw through the washer and the blade and
into the accessory holder threaded hole.
4. Turn the screw clockwise until it is finger tight.
Notes:
a) Check to make sure the convex curve of the washer
is facing the head of the screw and the slots in the
edge of the washer fit over the alignment pins in the
accessory holder.
b) Make sure the alignment holes in the blade are still
mated with the alignment pins in the accessory holder.
5. Firmly tighten the screw with the 5 mm hex key.
Note: Check to make sure the holes in the blade are still
mated with the alignment pins on the accessory holder after
the screw is fully tightened.

Installing sandpaper

1. Install the hook & loop sanding pad onto the tool.
2. Firmly press the sandpaper (9) onto the hook & loop pad.
8