Table of Contents
Advertisement
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Fitting and removing accessories
1. Clean and grease the
accessory's shank.
2. Pull out the bit lock pin (10)
and rotate it 180°.
3. Insert the shank of the accessory
into the chuck. Ensure
the notch in the shank is
positioned upward as per
image shown on the right.
Should the notch be in the
incorrect position the shank
will not lock into position.
4. Lock the shank into the nose
of the tool by pulling out the bit
lock and rotating it 180°.
5. Pull the accessory to ensure
the shank is properly secured
into the nose of the tool prior to operation.
6. To remove the accessory, pull out the bit lock, rotate 180°
and pull the accessory from the nose of the tool.
Note:
To avoid damage to the bit lock, only use round hex
shank bits. Damage caused to the bit lock by using incorrect
accessories will not be covered under warranty.
Auxiliary handle
1. Loosen the nut (7) anti
clockwise to loosen the collar,
rotate the handle to suit the
application.
2. Tighten the nut so the handle
is secure and will not slip.
Switching on and off
Connect the plug to the power
point.
Depress the ON/OFF switch (5)
which will start the unit.
Release the switch to stop the
unit.
For prolonged use pull the switch
on and depress the lock-on
button (6).
8
Advertisement
Table of Contents
