Safety Warnings Specific For Polishing Operations; Additional Safety Instructions For Wire Brushing Operations; Accessories; Multifunction Power Tool Use - 909 909004DEC Instruction Manual

Safety Warnings Specific for
Polishing Operations:
a) Do not allow any loose portion of the polishing bonnet
or its attachment strings to spin freely. Tuck away or
trim any loose attachment strings.
attachment strings can entangle your fingers or snag on the
workpiece.
Additional safety instructions
for wire brushing operations
Safety Warnings Specific for Wire Brushing Operations:
a) Be aware that wire bristles are thrown by the brush even
during ordinary operation. Do not overstress the wires by
applying excessive load to the brush. The wire bristles can
easily penetrate light clothing
b) If the use of a guard is recommended for wire brushing.
Do not allow any interference of the wire wheel or brush
with the guard. Wire wheel or brush may expand in diameter
due to work load and centrifugal forces.
WARNING. We recommend the use of a residual current device
with a residual current rating of 30mA or less.

Multifunction power tool use

This rotary tool can be used for drilling, grinding, sanding and
polishing, as well as engraving, cutting and removing rust in tight
spaces or inaccessible places. The tool can be used on most
metals, glass, wood and ceramics. For best performance and
results keep the speed as even as possible without exercising
too much pressure. As a guideline, use the tool at low speed for
all large accessories, such as polishing for example, and at high
speed for smaller accessories such as those used for engraving.
For grinding and engraving, hold the tool as if it were a pen.

Multifunction power tool start-up

Never start up or stop the tool is the accessory is in contact with
the piece to be worked on. Hold it firmly and press the ON/OFF
switch. The tool will run continuously until the switch is turned
to OFF position. The speed can be adjusted while the tool is
running.
Loose and spinning
and/or skin.

Speed adjustment

The multifunction power tool is equipped with speed control.
Do not change the speed while the tool is working. The
speed switch is located on the top of the tool. Speed
can be increased by pressing the "+" button, or reduced
be pressing the "-" button. Use the tool at low speed for
polishing and similar operations, but use higher speed for
drilling or cutting action.

Important general safety tips!

1. The Tool should be unplugged when changing

accessories.

2. If you stall the tool, switch it off immediately.
3. Periodically check the tightness of your collet chuck,
especially during prolonged use of the same accessory.
4. After use, always disconnect your power tool.
5. Do not undertake repair of the power tool your self.
6. Do not leave your tool unattended while switched on.
7. Do not use or store your tool in damp or wet conditions.
Useful hints & tips
1. Your rotary tool will become warm after prolonged use
and so must be switched off and allowed to cool down.
2. To ensure smooth running, the spindle should be oiled
periodically.
3. Do not apply too much radial pressure to the accessory
bits while polishing, cleaning, sanding or grinding.
By doing this you will put a strain on the spindle and
adversely affect the precision of the tool.
4. Always work with a sensitive touch so as not to impede
the efficiency of your mini tool.
5. When drilling metal, always mark the drilling point with a
centre punch first, so that your rotary tool does not slip.
6. Always ensure that you have maximum contact between
the accessory shaft and the collet chuck.
7. Vary the speed on the tool for the work in hand, eg.
Low speed for polishing & cleaning and high speed for
9