Stop The Snowthrower; Snowthrower Safety Test - Briggs & Stratton 1695904 Operator's Manual

Operation

Stop the Snowthrower

WARNING
Read Operator's Manual before operating machine.
This machine can be dangerous if used carelessly.
• Never operate the snowthrower without all guards,
covers, and shields in place.
• Never direct discharge towards windows or allow
bystanders near machine while engine is running.
• Stop the engine whenever leaving the operating
position.
• Disconnect spark plug before unclogging the
impeller housing or the discharge chute and before
making repairs or adjustments.
• When leaving the machine, remove the safety key.
To reduce the risk of fire, keep the machine clean
and free from spilled gas, oil, and debris.
WARNING
Never run engine indoors or in an
enclosed, poorly ventilated area. Engine
exhaust contains CARBON MONOXIDE,
an ODORLESS and DEADLY GAS.
• Keep hands, feet, hair, and loose clothing away from
any moving parts on engine and snowthrower.
• Temperature of muffler and nearby areas can
exceed 150°F (66°C). Avoid these areas.
• DO NOT allow children to operate or be near
snowthrower while it is operating.
1. Release the auger control (A, Figure 9).
2. Turn the ON/OFF switch (B) to the OFF position and
remove or pull out PUSH/PULL key.
16
A
B
Figure 9

Snowthrower Safety Test

WARNING
Never run engine indoors or in an
enclosed, poorly ventilated area. The
discharge chute contains a rotating auger
to throw snow. Never clear or unclog the
discharge chute with your hands.
Fingers can quickly become caught and traumatic
amputation or severe laceration will result. Always use
a clean-out tool to clear or unclog the discharge chute.
WARNING
• Hand contact with the rotating auger
inside the discharge chute is the most
common cause of injury associated
with snowthrowers.
• This snowthrower is capable of amputating hands
and feet, and throwing objects. Read and observe
all the safety instructions in this manual. Failure to
do so will result in death or serious injury.
Test - Auger/Impeller
1. Start unit and engage auger control (A, Figure 9).
2. Release auger control.
3. Auger must stop in 5 seconds or less.