Ip And Bridging Submenu - Funkwerk bintec R230a User Manual

2
Wireless Interface Submenu
Additional buttons
12 bintec User's Guide
Default behaviour: If A
DMIN
as A S = enabled is set and no MAC address is listed in the ACCEPT
DMIN TATUS
list, all clients are blocked. Only those clients whos MAC addresses are then en-
tered manually into the ACCEPT list or are moved from the REJECT to the
ACCEPT list are accepted.
The REFRESH button reloads the REJECT list, so that at any time the current
status of rejects can be listed.
With the REMOVE button selected addresses can be deleted from the ACCEPT
list. Removing an address from the ACCEPT list immediately disconnects an es-
tablished link.
The menu consists of the following fields:
Field
AdminStatus
Accept Address
Table 2-2: MAC F menu fields
ILTER
2.2

IP and Bridging Submenu

The fields of the IP B
AND
S = disabled, all clients are accepted. As soon
TATUS
Description
Enable or disable the filter for this wireless
interface.
Possible values: enable, disable (default value)
Enter a MAC address to be accepted.
Possible values: 12 digit MAC addresses; the
addresses are entered without any ":".
Press ADD to add the entered MAC address to
the ACCEPT list.
If you highlight an entry from the REJECT list
and press a (must be lowercase) on your key-
board, the respective entry is moved to the
ACCEPT list. Thus you do not have to manually
enter acceptable addresses.
submenu are described below.
RIDGING
Wireless LAN