Contact may cause skin burns. small pieces of dry wood on top. Your PACIFIC ENERGY heater is designed for many years of 3) Ignite the paper and close the door. trouble free operation. Over fi ring the appliance will shorten the life of the product.
COMPONENT OF THIS UNIT, CONTACT YOUR NEAREST impact glass. When closing door, make sure that no logs PACIFIC ENERGY DEALER. ONLY USE ORIGINAL PACIFIC- protrude to impact the glass. If the glass gets cracked or ENERGY PARTS AND COMPONENTS WHEN REPLACING.
Power Cord Position Fig. # 5 The power cord for the NEO 2.5 Insert comes factory set to exit the right side of the unit. If you desire, the cord can be switched to exit to the left of the unit. The cord will lose approximately 12”(305mm) of length when exiting the left side of the unit.
Firebrick Installation Instructions NEO 2.5 Insert This package contains 18 full-size fi rebricks, as well as 5 various cut-size bricks. With the heater in the upright position, install fi rebricks as follows: - Place 6 full-size fi rebricks and bricks C & D on the bottom of the heater fi rst in the pattern shown below.
MODEL / MODÈLE: NEO 2.5 INSERT SERIES / SÉRIE: A INSTALL AND USE ONLY IN ACCORDANCE WITH PACIFIC ENERGY’S INSTALLATION AND OPERATING INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT CODES, RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA. INSTALL AND USE ONLY IN MASONRY OR FACTORY BUILT FIREPLACE. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.