R e set t i n g T h e I nc l i n e M o to r A f t e r R ep l a c i n g Th e M o t or C o n t r o l Boar d
Tools Required:
• Philips Screwdriver
• 17mm Socket
• 17mm Combination Wrench
Procedure:
1) Turn off power to the treadmill and unplug power cord from wall outlet.
2) Replace the Motor Control Board.
3) Fold treadmill into locked position.
4) Undo bolt that attaches the elevation tube to the bottom of the machine (Figure 1)
5) Power up the machine and let the incline spin freely in the tube until it reaches its "zero" position, and then turn
power off.
6) Spin shaft manually until it is almost flush with the incline motor casing and only about 1 thread is visible (Figure 2).
7) Reinsert bolt and power up the machine.
8) Test the incline function and calibrate the unit.
26 | rst 5.6 & rct 7.6 service manual 2007_rev1.0
R S T5. 6 & R CT 7 . 6 S e a r s S e r v i c e M a n u a l 2 0 0 7
Figure 1
F i g u r e 2