Engineering Mode - Horizon Fitness RST 5.6 Service Manual

Treadmill Engineering Menu Definition
General
• Hold Incline + and Speed - for 3 seconds
• Speed +/- navigates once entered
• Enter Selects modes
• Hold Stop for three seconds to exit modes
• Defaults to Eng0
• Defaults to scrolling "ENGINEERING MENU"
o Will scroll "DISPLAY TEST" if navigated back to Eng0
Eng0 (Display Test)
• The information portion of the display will show "Eng0"
• The matrix will scroll "DISPLAY TEST"
• When selected, all display segments should be on
• When pressed, each button will beep and have a unique display change
o Stop turn all display segments off
o Start turns all display segments on
o If there is scrolling speed and incline, the display will scroll the speed or incline when the quick keys are pressed
Eng1 (Hardware Test)
• The information portion of the display will show "Eng1"
• The matrix will scroll "HARDWARE TEST"
• After entered, press Start to begin
Eng2 (Auto Calibration)
• The information portion of the display will show "Eng2"
• The matrix will scroll "AUTO CALIBRATE"
• After entered, press Start to begin
• There should be no excessive speed overshoot
• The Engineering Menu will be exited upon successful completion
Eng3 (Switch Function)
• The information portion of the display will show "Eng3"
• The matrix will scroll "SWITCH FUNCTION"
• Start selects miles or km
o The display will show "0" for miles or "1" for km
o The display will scroll "MILES" or "KM" when Start is pressed to change
o The new setting is automatically saved when Start is pressed, no other buttons need to be pressed to save
• Enter changes the model, if applicable
o The new setting is automatically saved
R S T5. 6 & R CT 7 . 6 S e a r s S e r v i c e M a n u a l 2 0 0 7
E ng in e e r i n g M o d e
rst 5.6 & rct 7.6 service manual 2007_rev1.0 | 15