Chapter 2: Engineering Mode - Horizon Fitness T4000 Premier Service Manual

2.1 ENGINEERING MODE
1) To enter Engineering Mode, press & hold the INCLINE
UP "▲" and SPEED DOWN
for 3-5 seconds until Engineering Menu appears on the
display.
2) Use the INCLINE and SPEED UP and DOWN keys to
select a parameter.
3) Press ENTER to enter a parameter setting.
4) Use the INCLINE and SPEED UP and DOWN keys to
change the parameter.
5) Press the START key to save the change to the parameter.
6) Press and hold the STOP key to exit Engineering Mode and return to normal operation.
MODE FUNCTION
ENG 0 Display Test
ENG 1 Hardware Test
ENG 2 Auto Calibration
ENG 3 Manual Calibration
ENG 4 Roller diameter
switch

CHAPTER 2: Engineering Mode

"－ － － － "
keys at the same time
Start Key – LCD/LED on
Stop Key – LCD/LED off
Any Other Key - Will show on the display window.
Hold the STOP key for 3 seconds to return to the Engineering Menu.
Motor & Incline Motor Test.
Auto calibrates the speed only.
To setup speed by manual (see flow chart as below)
P1: Low speed
P2: Low-Mid speed
P3: Mid speed
P4: Mid-High speed
P5: High Speed.
Roller diameter adjustment to match up real speed
UP key: +1
FAST key: +10
DOWN key: -1
SLOW key: +10
Hold START key 3sec to save parameter
4
DESCRIPTION