Service Software; General; Hardware Requirements For Windows 3.11; Hardware Requirements For Windows 95/98/Nt - Nokia NSM–3 Service Manual

NSM–3/3D
Service Software Instructions

Service Software

General

To run the Service Software, a parallel port software protection device
(PKD–1) has to be connected. TDF–4 box must connected to PC for
flashing purposes. The test functions send test messages from PC to mo-
bile stations (MS) and receive results and show them in the PC display.
The messages can be sent via M2BUS or FBUS.
Note: if this software is to be run on laptops, the power saving feature
MUST be switched off.

Hardware requirements for Windows 3.11

The recommended minimum hardware standard to run Service Software
is any computer which is 386 33 MHz or greater with at least 4 MB of
memory and VGA type display (640 x 480). This assumes that only the
WinTesla with phone module is active, i.e. other Windows packages are
not running in the background.

Hardware requirements for Windows 95/98/NT

The recommended minimum hardware standard to run Service Software
is any computer which has Pentium processor, memory 8 MB and meets
HW requirements recommended by Microsoft.

Software Environment of the Support Modules

The Service Software user interface is intended for the following environ-
ments: Microsoft Windows 3.11 (enhanced mode) and Windows
95/98/NT. Detailed information about Windows and application usage can
be found from the Microsoft Windows Users Guide.
As an ordinary Windows application, the main idea in the user interface is
that selections are made with menus, push buttons and shortcut keys.
Selections can be done by using keyboard and/or mouse. There is always
a status bar displayed at the bottom of the main window which contains
information about current actions.
Page 4
E Nokia Mobile Phones Ltd.
PAMS Technical Documentation
Issue 4 02/2002