Nokia NSM–3 Service Manual page 150

NSM–3/3D
Service Software Instructions
Channel edit box (ALT+H):
Monitoring Channel edit box (ALT+M):
Continuous Mode Channel edit box (ALT+C):
Gain Step Value edit box (ALT+L):
AFC edit box (ALT+F):
Apply button (ALT+A):
Note! Active Unit and Operation mode are not send with because they are
activated immediately.
Set Defaults button (ALT+S):
Get Defaults button (ALT+U):
The next automatic selection is made when Quick testing function is en-
ded:
The next table shows the dialog's properties on different situations:
ACTIVE UNIT = TX:
Page 42
The user can enter here a channel number that is used for
both transmission and receiving. The frequency of the selected
channel is shown after selection.
This field selects an adjacent monitoring channel. The frequen-
cy of the selected channel is shown after selection.
To this edit box the user can type continuous mode channel
which may have all channel numbers.
The used frequency depends on the Active Unit. If Active Unit
is RX, then RX frequency is used, else TX frequency. The fre-
quency of the selected channel is shown after selection.
This selection allows the user to set up the receiver gain step
in continuous mode. There are nine (0...8) steps. In the burst
mode selection is automatic.
This selection allows the user manually tune the 26 MHz clock.
Limits are –1023...–1024
Accepts entered values and validates them. After validation ap-
plication sends corresponding messages to ME. Closes dialog
and updates Info Window.
Sets current values as default Rf Controls values.
Gets default Rf Controls values as current values.
Active Unit = RX
Update RF Information window
TX Data Type: Updated
AGC values: Greyed
Monitoring Channel: Greyed
E Nokia Mobile Phones Ltd.
PAMS Technical Documentation
Issue 4 02/2002