Page 4
NSM-9DX Disassembly Instructions CCS Technical Documentation Remove A-cover. Remove Keypad (only if it is necessary to re place keypad). In assembly place A-cove pins (4 pieces) in respecti holes in the keypad. Page 4 ¤Nokia Corporation Issue 1 10/02...
Page 5
NSM-9DX CCS Technical Documentation Disassembly Instructions Remove the 6 screws. Drive size is torx plus 6. Tightening torque is 17 Ncm. , and 1100rpm. Fastening order in the picture in disassembly. In assembly check that PWB is not bent. Note! Screws contain thread lock ing compound.
Page 6
NSM-9DX Disassembly Instructions CCS Technical Documentation UI handling precautions! 1. Speaker spring contacts 2. LCD driver. 3. LCD contact pads. 4. UI PWB contact pads. 5. UI frame metal coating. Remove speaker (only if it is necessary to re speaker).
Page 7
NSM-9DX CCS Technical Documentation Disassembly Instructions Remove System Module System Module handling pre cautions! Do not touch the following spring contacts when handling the module: 1. LCD connector. 2. Board to board connector. Remove System connector Note! Do not damage the spring contacts in the System connector.
Page 8
NSM-9DX Disassembly Instructions CCS Technical Documentation Remove SIM cover (only if it is necessary to replace SIM cover). 1. Slightly lift the front edge of the SIM cover to unlocked position 2. and slide it backwards. 3. Turn the SIM cover to upright position.
Page 9
CCS Technical Documentation Disassembly Instructions NSM-9DX No power and A-cover fit If a “No power” problem is found, please check the A-cover fit. Below are pictures of good fit and bad fit. The engine needs to be fully fitted into the A-cover and the phone will power up.